Thermodynamic Steam Trap TDS 30-52

Working Range: Thermodynamic Steam Trap TDS 30-52 steam trap is useful device to evacuate condensate from steam line, its size varies from DN15 to DN25 or 1″ to 1/2″ as, Screwed, Socket and Flanged connection. The working pressure is 42bar and maximum working temperature is 400ºC.this steam trap is produced based on DIN and ANSI standards.

Function: In steam line and its related equipment, steam creates condensate in effect of contacting with environment and exchange of heat. This condensate causes to water hammering in line, decrease temperature of system and steam can not move in tubes appropriately. To avoid mentioned problems and increasing efficiently of system and also to transfer maximum thermal force, this condensate must be exited of the line immediately and guided to condensate tanks. stream trap is useful device to do this. Thermo-dynamic steam trap is famous as disc trap. Function of this device is based on a plug and it’s seat and thermo-dynamic laws. To prevent environment corrosion, the exterior surface of this device is covered by heat resistant coat base on ASTM, IPS standard. TDS 30-52 is used in steam line, Driers, pressure units. heater machines and … a lot, because of its simple structure, low weight & mass, using in average and lower than 42 bar pressure   high draining capacity, resistance to the freezing, corrosion and water hammering.

Installation: Type TDS 30-52 steam traps can be installed vertically or horizontally.  Flow direction must be corresponded with arrow direction on the body.

Insulating Cover: It is used in case client order. This device is stainless steel and installed to prevent heat loss and protect trap when subjected to rain and wind or environment temperature changes.

Drain Valve: It is used in case client order. It is installed in socket and Screwed trap to discharge extra gasses or air and condensate of strainer. For more information, refer to TDS 30-52 catalog.